Union Tool Carbide End Mill Square Outer Diameter φ8 x Blade Length 24 CXES4080-2400 1 Piece

Catalog number: CXES4080-2400 Features: ● Unequal division and unequal lead specifications suppress chatter vibration. ● High toughness type of carbide material that is difficult to chip is used, and fine tuning including special groove shape is applied to enable ultra-high efficiency cutting that has never been seen before. ● Not only high efficiency cutting but also good finish surface can be obtained in finishing cutting. ● Low friction coating is applied, achieving outstanding chip removal and wear resistance. Applications: ● Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper, titanium alloy, super heat-resistant alloy Specifications: ● Outside diameter: 8 ● Blade length (l): 24 ● Outside diameter (d): 8 ● Blade length (L): 24 ● Total length (L): 70 ● Shank diameter (d): 8 Material / Finish: ● Carbide fine particle alloy (Super MG) Note: ● Shank taper angle is a guideline. ● If interference with the workpiece is required, be sure to measure it and check it. ●Be careful of contact between the shank and the workpiece.