Union Tool Carbide End Mill CXES4015-0375 1 piece

Catalog number: CXES4015-0375 Features: * Unequal division and unequal lead specifications suppress chatter vibration. * Highly tough carbide material is used that is resistant to chipping, and fine tuning including a special groove shape enables ultra-efficient cutting that has never been seen before. * It is possible to obtain a good surface finish not only in highly efficient cutting but also in finishing cutting. * A low-friction coating is applied, achieving outstanding chip removal and wear resistance. Uses: ●Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper, titanium alloy, super heat-resistant alloy Specifications: ●Outer diameter: 1.5 ●Blade length (l): 3.75 ●Shank taper angle (Bta) (°): 16 ●Outer diameter (d): 1.5 ●Blade length (L): 3.75 ●Total length (L): 50 ●Shank diameter (d): 4 Material/Finish: ●Super-hard fine particle alloy (Super MG) Note: ●The shank taper angle is a guideline. ●If interference with the workpiece is required, be sure to measure it and confirm. ●Please be careful of contact between the shank and the workpiece.