Union Tool Carbide End Mill CXES4080-2000 1 piece

Catalog number: CXES4080-2000 Features: * Unequal division and unequal lead specifications suppress chatter vibration. * Highly tough carbide material is used that is resistant to chipping, and fine tuning including a special groove shape enables ultra-efficient cutting that has never been seen before. * It is possible to obtain a good surface finish not only in highly efficient cutting but also in finishing cutting. * A low-friction coating is applied, achieving outstanding chip removal and wear resistance. Uses: ●Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper, titanium alloy, super heat-resistant alloy Specifications: ●Outer diameter: 8 ●Blade length (l): 20 ●Outer diameter (d): 8 ●Blade length (L): 20 ●Total length (L): 60 ●Shank diameter (d): 8 ●Made in an ISO9001 certified factory ●Made in an ISO14001 certified factory ●UT coating ●Twist angle 37°-40° ●Unequal division Unequal lead 4-blade high-efficiency square end mill CXES Material/Finish: ●Super-hard fine particle alloy (Super MG) Note: ●The shank taper angle is a guideline. ●If interference with the workpiece is required, be sure to measure it and check it. ●Please be careful of contact between the shank and the workpiece.