Union Tool Carbide End Mill CXS4030-160 1 piece

Catalog number: CXS4030-160 Features: ● Unequal division and unequal lead specifications suppress chatter vibration. ● High toughness type carbide material that is difficult to chip is used, and fine tuning including special groove shape is applied, making it possible to achieve ultra-high efficiency cutting that has never been seen before. ● Not only high efficiency cutting but also good finish surface can be obtained in finishing cutting. ● Low friction coating is applied, achieving outstanding chip removal and wear resistance. Applications: ● Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper, titanium alloy, super heat-resistant alloy Specifications: ● UT coating ● Twist angle 37° to 40° ● Unequal division Unequal lead 4-blade high efficiency long neck square end mill CXS Material / Finish: ● Carbide fine particle alloy (Super MG) Note: ● Shank taper angle is a guideline. ● If interference with the workpiece is required, be sure to measure it and check it. ● Be careful of contact between the shank and the workpiece. ●To prevent the tip of the blade from shaking, do not chuck the shank part that has coating on it.