Union Tool 4-blade unequal division unequal lead high efficiency square CXES outer diameter 1 x blade length 4 x total length 60 x shank diameter 4 CXES4010-0400 1 piece

Catalog number: CXES4010-0400 Features: * Unequal division and unequal lead specifications suppress chatter vibration. * Highly tough carbide material is used that is less likely to chip, and fine tuning including a special groove shape enables ultra-efficient cutting that has never been seen before. * It is possible to obtain a good surface finish not only in highly efficient machining but also in finishing machining. * A low-friction coating is applied, achieving outstanding chip removal and wear resistance. Uses: ●Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, copper, hardened steel (up to 55HRC), cast iron, titanium alloy, super heat-resistant alloy Specifications: ●Blade length (mm): 4 ●Shank diameter (mm): 4 ●Number of blades (pieces): 4 ●Total length (mm): 60 ●Surface treatment: UTCOAT ●Outer diameter (mm): 1 ●Number of blades: 4 ●4-blade UTCOAT ●Made in an ISO9001 certified factory ●Made in an ISO14001 certified factory ●Unequal division and unequal lead specifications Material/Finish: ●SuperMG Note: ●The shank taper angle is a guideline. ●If you are concerned about interference with the workpiece, be sure to measure it and check it. ●The tool outer diameter may be smaller than the shank diameter. ●Please be careful of contact between the shank and the workpiece.