Union Tool 4-Blade High Efficiency Long Neck Square End Mill, Outer Diameter 5 x Effective Length 15 x Blade Length 7.5 x Total Length 50 x Shank Diameter 6 CXS4050-150 1 Piece

Catalog number: CXS4050-150 Features: * Unequal division and unequal lead specifications suppress chatter vibration. * Highly tough carbide material is used that is resistant to chipping, and fine tuning including a special groove shape enables ultra-highly efficient heavy cutting that has never been seen before. * Good surface finish can be obtained not only in heavy cutting but also in finishing cutting. * Low-friction coating is used, achieving outstanding chip removal and wear resistance. Uses: ● Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper (wet), titanium alloy (wet), super heat-resistant alloy (wet) Specifications: ● Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper (wet), titanium alloy (wet), super heat-resistant alloy (wet) ● Corner R ● UT coating ● Twist angle 37° to 40° ● Unequal division Unequal lead 4-blade high-efficiency long-neck square end mill CXS Material/Finish: ● Carbide fine particle alloy (Super MG) Note: ● The shank taper angle is a guideline. ● Be sure to measure and confirm if interference with the workpiece is required. ● Be careful of contact between the shank and the workpiece. ● To prevent the blade tip from vibrating, do not chuck the shank part that has coating on it.