Wall-Pita Tissue KM-172 1 pc

This is a holder that stores tissue boxes by attaching them to the wall! By attaching tissues to the wall and storing them, you can make effective use of space, and by placing them in a fixed location, they are easy to use. By simply sticking it on, you can place tissue boxes in various places. ●Uses a peel-and-stick "Kuripita Sheet." Re-sticking is OK! ●You can stick it on the wall even if the space is small and you don't have space to put it. ●Save space by using the open space for storage. ●It's convenient because daily necessities are located in a designated place. ●For use in the kitchen, bathroom, living room, under desks, etc. [Material] Body: ABS resin Adhesive layer: Special polyurethane, acrylic foam [Product size/weight] 140×65×38mm／22g [Load capacity] Up to 350g [Applicable box short side size] 11.2-12cm [How to set the holder] (1) Wipe off any dirt on the surface where you want to attach the holder using a cloth or similar. (2) Peel off the release film from the adhesive surface and rinse the adhesive surface with water. Dry it thoroughly and then press the entire adhesive surface firmly onto the mounting surface for about 30 seconds. *Please wait at least 2 hours after application before using. ★How to attach the tissue box Press it straight in perpendicular to the holder to secure it in place. ★How to remove the tissue box Grasp the tissue box and slowly open either the left or right flap to remove the tissue. [Caution] - Do not use boxes of tissues that weigh more than 350g. - Do not install the tissue box in a way that causes it to be upside down. - Please make sure that it is firmly attached before using. - If the adhesive surface is dirty, the adhesive strength will be weakened, so make sure the adhesive surface is clean before use. - Do not attach to floors or other areas where it may be stepped on. ・Never apply the sticker to the inapplicable surfaces listed above. The sticker may come off, or the wall may become dirty or damaged. - Please attach it in a place where it is okay if it leaves a mark when you remove it. ・When using in winter or other cold weather when the temperature is below 8 degrees, warm the adhesive surface slightly with a hair dryer before applying. After application, it is fine even if the temperature is below 8 degrees. -It can be used around the sink and kitchen, but please note that its holding power may decrease in places where it is exposed to direct water or high temperatures. ・Please peel it off slowly. Peeling it off forcefully may damage the surface of the other side. (When peeled off, some of the gray adhesive layer may remain on the other side, but it can be cleaned by scraping it off with your fingernail or wiping it off with a wet cloth.) ・Once you remove the holder from the wall, be sure to rinse the adhesive surface with water and dry it thoroughly before reattaching it. (Washing with water will restore most of the adhesive power.) ・Please store and use the product in a car, bathroom, or away from direct sunlight. ・The load capacity is an estimate. Please note that it may vary depending on the usage conditions. - Keep out of reach of children. - Do not use for any purpose other than its intended use.