Asahi EAZY WELD Aluminum Rod AL450 5 pieces/set 1053 1 set

Catalog number: 1053 Features: ●Easy welding that requires no equipment and has strength about 5 times that of soldering. ●Heat the welding base material until it reaches the working temperature of the various rods (welding rods). ●Use an infrared thermometer to check the appropriate temperature before working to achieve better results. ●Keep the base material at the appropriate rod melting temperature. ●Rub the rod against the base material to melt it at the temperature of the base material and perform the repair work. ●Allow the melted rod to cool naturally for about 1 minute until it loses its luster. Uses: ●For welding and repairing aluminum. Specifications: ●Type: For aluminum ●Capacity: Five times stronger than solder ●Shear strength (PSI): 34000 ●Compressive strength (PSI): 60000 ●Tensile strength (PSI): 39000 ●Conductivity (%IACS): 24.9 ●Heat resistance temperature (℃): 379-391 ●Set of 5 aluminum rods ●Dimensions (mm): φ3×450 ●Maximum operating temperature (℃): 391 ●Set of 5 aluminum rods ●Size (wire diameter x length): φ3×450mm (only part number 1056 is 5×5×350mm) Material/Finish: ●Aluminum ●Zinc ●Copper ●Magnesium Caution: ● Leaving scraped-off iron filings behind when working can cause corrosion. ● Be careful not to overheat the base material and melt it. For aluminum over 5mm thick, it is very difficult to maintain the working temperature with the included gas burner, so please use acetylene gas. If the base material is difficult to heat up, placing a fireproof brick underneath it will increase efficiency. ● Do not expose the rod (welding rod) to direct flame. ● Rapid cooling with water etc. will significantly reduce its strength. Blowing air at a material that is not yet solidified will cause it to fly off and is very dangerous. Overheating will cause it to repel and will not weld.