Ultrasonic cutter ZO-40 Resin 1 piece

Easy-to-understand operation that only works when the handpiece switch is pressed Safety design that stops the ultrasound if too much pressure is applied More powerful than previous models (ZO-40W/ZO-40B) (cutting speed 4% faster: our comparison) High-speed vibrations of approximately 40,000 times per second allow for smooth cutting with little force. [Caution/Conditions of Use] *2: The temperature ranges shown in the environmental conditions do not guarantee performance. Anything that cannot be cut with a normal cutter cannot be cut with an ultrasonic cutter either. Using the horn for long periods of time (about 10 minutes) may cause the horn to heat up. Applying a force of more than 3 kg to the blade tip may cause the blade to slip from the blade fixing bracket, overheat, or become damaged. The time it takes to heat up will vary depending on the conditions of use. If it heats up, stop using it immediately. Wait until the temperature has dropped before using it again. When using or replacing the blade, please wear safety glasses and gloves. Depending on the material being cut, toxic gases may be generated. Wear a mask and ensure proper ventilation. Product weight (g): 460 Standard accessories: Spare blade (BDC-200P x 1), blade fixing tool x 1, blade fixing screws x 3, hexagonal wrench x 1, protector x 1 Oscillation frequency: 40kHz Power consumption: Maximum approx. 25VA Rated voltage: AC100V Oscillator dimensions (mm): 173 x 89 x 76 (excluding protrusions) Mass of oscillator (g): Approx. 360 Handpiece dimensions (mm): φ32×144 (including blade) Handpiece weight (g): Approx. 100 (including output cord) Handpiece cable length (m): 1.6 (straight) Environmental conditions: 10 to 35°C, humidity 20 to 70% (but no condensation) (*2) Cuttable resins (approximate): ABS, PP, PET, acrylic Cuttable thickness (approximate): 3mm or less Circuit protection: If a large force is applied when cutting, ultrasonic vibration stops for safety reasons.