SANWA Digital Insulation Tester 1000V/500V/250V MG1000 1 pc

Catalog number: MG1000 Features: ● Test rod body storage and protective case integrated. ● Equipped with auto-hold function to fix the last measured value. ● Equipped with automatic discrimination function for DC voltage, AC voltage. ● Compliant with international safety standard CAT.[3]600V ● Dustproof and splashproof (IP54) design ● Rated voltage for insulation resistance measurement can be switched between three ranges: 250V/500V/1000V ● Automatic discrimination of live line status with insulation resistance measurement function ● Large, easy-to-read numerical values ​​and analog bar graphs ● Automatically holds the last measured value after measurement ● Backlit LCD display Applications: ● For measuring the insulation resistance of equipment. ● For measuring the insulation resistance of low-voltage circuits. ● For measuring the insulation resistance of switchboards, etc. Specifications: ● Rated measurement voltage (V/MΩ): 250/4000, 500/4000, 1000/4000 ● Minimum display (MΩ): 0.001 ● AC voltage (V): 600 ● DC voltage (V): 600 ● Width (mm): 142 ● Depth (mm): 57 ● Height (mm): 170 ● Power supply (V): 6 AA batteries (LR6) (included) ● Calibration documents: Supported ● Continuous use time (h): Approximately 150 hours ● Protection rating: IP54 (dustproof and water-resistant) ● Compliant with JIS C1302-2002 ● Automatic ACV/DCV discrimination ● CE mark compatible ● Compliant with international safety standard CAT.3.600V ● Safety is also taken into consideration as the 1000V range cannot be used unless the function switch is turned while pressing the 0ΩADJ button. Set contents/accessories: ●Test lead (TL-112a) ●Strap (ST-50) ●Instruction manual Caution: ●Do not use if the main unit, measurement probe, alligator clip, or earth lead is damaged. ●Do not use in locations where corrosive or explosive gases are generated. ●Do not hold the tip of the measurement probe or alligator clip beyond the barrier during measurement. ●Connect the ground side (alligator clip) first, then connect the live side (measurement probe). When disconnecting, first move away from the live side. ●Do not switch to other functions during measurement.