SANWA Digital Insulation Tester 500V/250V/125V MG500 1 pc

Catalog number: MG500 Features: ● Test rod body storage and protective case integrated. ● Equipped with auto-hold function to fix the last measured value. ● Equipped with automatic discrimination function for DC voltage and AC voltage. ● Compliant with international safety standard CAT.[3]600V ● Equipped with display backlight for easy viewing even in dark places. ● Rated voltage for insulation resistance measurement can be switched between three ranges: 125V/250V/500V ● Automatically detects live line status with insulation resistance measurement function ● Large, easy-to-read numerical values ​​and analog bar graph ● Dustproof and water-resistant (IP54) design ● Automatically holds the last measured value after measurement Applications: ● For measuring the insulation resistance of equipment. ● For measuring the insulation resistance of low-voltage circuits. ● For measuring the insulation resistance of switchboards, etc. Specifications: ● Rated measurement voltage (V/MΩ): 125/4000, 250/4000, 500/4000 ● Minimum display (MΩ): 0.0001 ● AC voltage (V): 600 ● DC voltage (V): 600 ● Width (mm): 142 ● Depth (mm): 57 ● Height (mm): 170 ● Power supply (V): 6 AA batteries (included) ● Calibration documents: Compatible ● Continuous use time (h): Approximately 150 hours ● Protection rating: IP54 (dustproof/waterproof) ● Compliant with JIS C1302-2002 ● Automatic ACV/DCV discrimination ● CE mark compatible ● Compliant with international safety standard CAT.3.600V ● Safety is also taken into consideration as the 500V range cannot be used unless the function switch is turned while the 0ΩADJ button is pressed. Set contents/accessories: ● Test lead (TL-112a) ● Strap (ST-50) ● Instruction manual Caution: ●Do not use if the main unit, measurement probe, alligator clip, or earth lead is damaged. ●Do not use in locations where corrosive or explosive gases are generated. ●Do not hold the tip of the measurement probe or alligator clip beyond the barrier during measurement. ●Connect the grounded side (alligator clip) first, then connect the live side (measurement probe). When disconnecting, first move away from the live side. ●Do not switch to another function during measurement.