SANWA Volt Tester KP1 1 unit

Catalog number: KP1 Features: ● Safe to use, compatible with CAT.IV 600V. ● Easier measurement, automatically distinguishes ACV/DCV, reducing erroneous measurements due to incorrect functions and breaker trips caused by careless mistakes. ● Equipped with diagnostic mode - check for lead breakage and display failure at any time. ● Two types of voltage detection function (EF): contact and non-contact. The voltage detection status can be judged by an easy-to-understand bar display and buzzer sound. ● True RMS measurement method can measure distorted waveforms. ● Backlight color changes at 20V or more. ● Backlight is convenient for measuring in dark places, and comes with an LED light to illuminate the work site. ● Auto data hold that automatically holds the measured value. ● Auto power off function that operates in about 1 minute (cannot be canceled). Applications: ● For electrical work. ● For electrical inspection of plants, etc. ● For facility building maintenance. ● For equipment maintenance. Specifications: ● DC voltage (V): 999.9 ● AC voltage (V): 999.9 ● Detection method: True RMS ● Continuity check: Buzzer sounds at approximately 20k to 500kΩ or less ● Calibration documents: Supported ● Power supply (V): 2 AAA alkaline batteries (LR03) (included) ● Width (mm): 90 ● Depth (mm): 30 ● Height (mm): 130 ● Power supply: 2 AAA alkaline batteries (LR03) (included) ● Detection method: True RMS ● Width x Depth x Height: 90 x 30 x 130 mm ● Power supply: 2 AAA alkaline batteries (LR03) (included) ● Maximum display: 9999 counts ● Battery life: 20 hours ● In voltage detection mode, the bar graph and intermittent sound change to 5 levels at approximately 60V or more (shared for 50/60Hz) ● When measuring voltage, it will not detect less than 5V. Set contents/accessories: ● Test lead (black) TL36 ● Test probe (red) TL-35 ● Test probe (black) TL-A01 ● Instruction manual Caution: ● This device is a voltage tester (voltmeter) with voltage detection function. Do not use on circuits exceeding 1000V. ● Do not input signals exceeding the maximum rated input value. ● Do not hold the test pin side of the test probe beyond the barrier during measurement. ● Do not use if the main unit or test leads are damaged or broken. ● Do not use in any way other than as specified, as this may impair the protective function of this device.