Dual volume A-weighted 10kΩ R1610G-QB1-A103 1 piece

This series is a dual-row variable resistor with a shaft diameter of φ6 mm. Even if the image is the same, the shaft length may differ, so please check the specifications (numbers). There are different types of variable resistors depending on the relationship between the shaft rotation angle and the change in resistance. Usually, A curve, B curve, and occasionally C curve are used. The A curve has an exponential change and is ideal for audio volume control. The B curve has a linear change and is used for voltage adjustments in general equipment. The C curve is the A curve with the direction of rotation reversed, and is used for adjusting amplifier gain. This is a dual-gang volume control with typical specifications (10kΩ, A curve) for adjusting volume. It is a panel-mounted type. Volume controls generally require special care, as stress and heat applied to the terminals can cause them to fail. The wire is soldered directly to the terminals, but if the wire is too thick and a large force is applied to the terminals, the eyelets that secure the terminals can easily loosen, so care must be taken. Also, with this type of resistor, the resistor body is not sealed, and dust can get in through the terminals and cause problems, so please protect it appropriately. Resistance change characteristic: A Resistance value: 10kΩ Resistance tolerance: ±20% Rated power: 0.06W External dimensions: φ16mm Shaft (φD×L): φ6×15mm Shaft: Groove type Mechanical rotation angle: - Operating temperature range: - Mounting: Panel mounting Rotational life: - Uses: General purpose, volume control (stereo) Accessories: screws, washers Note: For shaft length 20mm, see R1610-RB1-A103.