Dish towel adhesive 3 KP-248 1 pc

Oh, how convenient! It's a dish towel holder! The main body can be removed and washed! ●Installation method is adhesive. ●It can be attached to smooth surfaces without bumps or irregularities such as pillars, wooden walls, printed plywood, decorative plywood, tiles, glass, stainless steel, painted metal surfaces such as refrigerators and washing machines, and unpainted concrete. *Depending on the location, oil may be present. Wash thoroughly with lukewarm water mixed with a mild kitchen detergent, then dry thoroughly before installing. *Adhesive tape may not stick well to some printed plywood. Please rub the mounting surface with an eraser before installing. ●Cannot be installed on surfaces that are uneven, rough, or prone to peeling. - Fabric walls, wallpaper, vinyl wallpaper, earthen walls, plaster, mortar, painted walls, painted plywood. - Kitchens, bathrooms and other places where water droplets form or get wet. - Places that become hot, such as ranges or stoves. - Patterned tiles. [Load limit] 100g per arm [Materials Listing] Body: Steel, resin [Installation method] (1) Wash the walls with lukewarm water mixed with a mild kitchen detergent and then dry. (2) Peel off the paper on the back without touching the adhesive surface. (3) Press firmly on the entire mounting area to make sure the adhesive tape adheres to the wall. (If using tiles, be careful not to get the tape on the joints.) [How to remove if no longer needed] (1) Slide the cover up and remove it from the mounting part. (At this time, be sure to lay the arm to the side.) (2) Insert a knife between the wall and the mounting part and cut off the tape on the back. (Be careful not to injure yourself.) (3) Rub off any remaining tape from the wall with your fingers. [When installing with wood screws] (Please use your own wood screws (thickness 3 mm).) (1) Slide the mounting part down and remove it from the cover. (At this time, be sure to lay the arm to the side.) (2) Press the mounting part against the wall and use a cutter to drill pilot holes through the two wood screw holes at the top and bottom, and then screw in the wood screws. (3) Support the cover with one hand and insert the arm from above while pulling it. [Precautions for use] ・Please do not hang valuables or fragile items. -If there is dirt, dust, moisture, oil, wax, etc. on the walls, it will never run out. - Please attach it in a place where you don't mind it leaving a mark when you remove it. - In winter, warm the adhesive surface using a hair dryer or similar device before applying. - Please observe the load limit. - Avoid applying diagonal loads, such as by stretching ropes.