EBI Driving Board Anchor (100 pairs) MSN 1 box

Catalog number: MSN Features: ● No pilot holes are required, just hammer in for easy installation. ● The white, small, thin head allows for inconspicuous installation. ● Less dust or dirt is produced during installation, and wallpaper peeling is reduced. ● The holding strength is equivalent to the screw-in type, and screws are included for excellent cost performance. ● If the screws are not screwed in, the marks left after removal are small and it is easy to correct the position. Uses: ● For mounting fixtures on wall base materials such as gypsum board (JIS: GB-R) 9.5 to 12.5 mm thick and veneer (lauan plywood) 4 to 5.5 mm thick. ● The white, small, thin head allows for inconspicuous installation. ● Less dust or dirt is produced during installation, and wallpaper peeling is reduced. ● The holding strength is equivalent to the screw-in type, and screws are included for excellent cost performance. ● If the screws are not screwed in, the marks left after removal are small and it is easy to correct the position. Specifications: ● Length (mm): 29.7 ● Suitable screw diameter (mm): 3.5-5 ● Pilot hole diameter (mm): No pilot hole required ● Total length (mm): 29.7 ● Head diameter (mm): 11.6 ● Suitable screw: φ3.5-4.5 tapping screw ● Suitable screw length: Mounting object + 20mm or more Material / Finish: ● Steel (surface white ruspart processing) Set contents / Accessories: ● Truss tapping screw M4 x 25mm Caution: ● Be sure to read the instruction manual carefully before working and use it correctly after fully understanding it. ● Dimensions and weight are nominal values, so there may be some fluctuation in the values. ● Use on hollow walls with space behind plasterboard or plywood. ● Hard plasterboard (JIS: GB-RH) cannot be used. Do not use downward load direction such as ceiling. ● Do not install with an impact driver. Be careful not to hit too hard or tighten too much.