Tsurumi Low Water Level Drain Submersible High Spin Pump 50Hz LSR2.4S 50HZ 1 unit

Catalog number: LSR2.4S 50HZ Features: ● Pumping is possible with 10mm of water from the bottom of the pump, and the minimum water level for continuous operation is 5mm. ● No priming required. ● Uses a high-spin impeller made of water-resistant special urethane rubber that is resistant to locking due to sand and mud, and boasts abrasion resistance approximately three times that of FCD material. ● Even if the bottom strainer becomes clogged, water can be sucked in through the side slits by the action of the rubber bellows. ● The bottom is made of synthetic rubber, from the pump casing to the stand. Suitable for use in FRP tanks, etc. ● Designed to not tip over even when the pump is turned upside down. Maintenance work can be done on the pump section with a single 13mm box wrench without removing the impeller. Uses: ● For low water level drainage. ● For floor water drainage and residual water drainage in general construction work. ● For draining bottom water and residual water from manholes, pits, and receiving and supply tanks. Specifications: ●Discharge volume (L/min): 120 ●Total head (m): 8 ●Frequency (Hz): 50 ●Caliber (mm): 50 ●Power supply (V): Single phase 100 ●Current (A): 6.8 ●Output (kW): 0.48 ●Total width (mm): 210 ●Total length (mm): 210 ●Total height (mm): 304 ●Foreign object passage diameter (mm): 6 ●Usable water quality: Cleaning water, floor water, accumulated water ●Power cord length (m): 5 ●Non-automatic operation type ●Power cord length: 5m ●Foreign object passage diameter: 6mm ●Can be customized to accommodate different voltages from one unit Material/Finish: ●Impeller: Water-resistant special urethane rubber ●Casing: Special synthetic rubber ●Suction cover: SPCC + synthetic rubber ●Shaft seal (mechanical seal): SiC Set contents/Accessories: ●Cabtyre cable (with pop-in plug) ●Hose coupling ●Hose band