Fumakilla Dora Death Power Strong Adhesive Sheet 2 Sheets 1 Piece

Get rid of them! Unique design based on thorough research into their ecology! Get rid of them with the strongest trap in Fumakilla history! ●Unique design! Adhesive up to 1cm from edge. Ultra-thin sheet. Top entry. ● Powerfully captures mice Adhesive strength 1.5 times stronger (compared to the manufacturer's previous product, adhesive strength test comparison) ●2-way type that can be used in different ways Flat against the wall. House in the gap. ★Installation points - It is effective when placed in places where you have seen or heard mice, or where there are traces of mice (feeding damage, feces, urine, etc.). - Mice have a habit of moving along the sides of walls, so setting up a trap along the side of a wall makes it easier to catch them. Place it as close to the wall as possible. ・If you do not catch any after 6 to 7 days, try changing the location or shape (flat or house). - If there is dust or other foreign matter around the installation location, clean it off. [Application] Capturing house mice [Target rats] For use in the house: House mice, Brown rats For flat use: House mice, brown rats, brown rats 【size】 House: Width 78 x Height 62 x Length 210 mm Flat: 270X210mm [How to use] *Please hold the outside of the main unit (black surface) while working. The inside surface (adhesive surface) has adhesive on it, so do not insert your hand inside the main unit. (1) When using in a house - Be careful not to touch the adhesive with your hands, and deform the triangle into a house shape. ・Fold the tab part ◆ along the crease. This will help keep the shape. ・Open the top opening ★. Be careful not to touch the adhesive when pushing it in. - Press the perforated area lightly with your finger to break the seam. If you don't fold the opening all the way in, leaving it in a slope, it will be easier for mice to get in. -When changing from flat to house, insert the claws into the claw sockets, adjust the shape, then bend the claws to secure them. (2) When used flat *Be careful not to touch the adhesive with your hands. ・Remove the tabs and open the main unit. Press the tabs with the pads of your fingers to remove the insert part. - To lay it flat, smooth out the creases and tabs. Fold the left and right sides in opposite directions until they can touch, then smooth out the creases firmly. Repeat this several times to make it easier to place it flat. *It will not be damaged if bent in the opposite direction, so be sure to bend it firmly. Place the sticker sticky side up in a location where mice are likely to pass through. *The entrance on the top will not be used, so do not open it. *When using the house flat, be sure to press down on the top entrance so that it does not float. *For large rats, connect two sheets together. Insert the tabs into the holes to connect. Be careful not to touch the adhesive. [If adhesive gets on the product] ・If it gets on people or pets: Apply baby oil or salad oil to the area with the adhesive, then rub it off with kitchen paper or similar. Then wash with soap or shampoo. ・If it gets on flooring or tatami mats: Remove as much adhesive as possible by tapping it with the sticky side of duct tape or similar. If any adhesive remains, clean it off with detergent or similar. ・If it gets on clothing or carpet: Remove as much of the adhesive as possible by tapping the area with the sticky surface of duct tape or similar. Apply baby oil or salad oil to the remaining adhesive and then remove it by pinching it off with kitchen paper or similar. After that, rinse with detergent and then dry. (Please also check the washing instructions on your clothes and carpets.) [Storage precautions] ・Store away from children and pets, in a cool, dark place and out of direct sunlight. [Precautions for use] - Be careful, as if the adhesive gets wet with water, dust, dirt, oil, etc., its adhesive strength will decrease and its capturing power will decrease. ・Do not touch the adhesive. If the adhesive gets on your hands or other parts of your body, please follow the instructions on the product packaging for what to do if adhesive gets on your hands. - Install in a place where children and pets cannot reach. - The caught mice may soil the surrounding area or leave adhesive on the backing paper. If you are installing the product in a location where you are concerned that the surrounding area may get dirty, please take precautions such as laying newspaper underneath the backing. - Dispose of any caught mice as soon as possible, including the sheet, as food waste. If you feel uncomfortable or unsafe, use fire tongs or something similar to dispose of the substance without touching it directly with your hands. - Place the sticky sheet without placing any bait on it (placing bait on it may alarm the mice and reduce its effectiveness). - Avoid placing the device in areas where people walk regularly. If placing them in areas where people walk, be sure to post signs or give verbal warnings to prevent them from being stepped on. - In low or high temperature locations (near a window, in direct sunlight, etc.), the adhesive strength may decrease and the capturing power may decrease.