Polyvent 36 (PTFE 0.2μm) 6713-5036 1 piece

Passed HIMA challenge test for sterilization grade Brevundimonas diminuta capture rate is over 10^7 CFU/cm2, conforming to ASTM standard F838-83 This microbial retention capacity correlates with 100% integrity testing (assessment on liquids) performed during the manufacturing process (100% integrity testing is only performed on capsule form). Developed for sterile venting, this one-piece filter is constructed from a single standardized material (PTFE membrane and polypropylene housing) which helps simplify the certification process. Hydrophobic PTFE membrane with pore size of 0.2 μm Can be sterilized by autoclave up to 50 times and is compatible with ethylene oxide gas Water Breakthrough (WBT) test or bubble point test available Manufactured in clean room facilities Can be used in both directions Note: For research and testing purposes only. Housing: Polypropylene Filter material: PTFE (polytetrafluoroethylene) Pore ​​size: 0.2μm Vent: Inlet side Support system: Polypropylene Bonding method: Heat welding Pressure resistance: 0.2MPa (29psi) (forward direction) Water immersion test: 0.2MPa (29psi) / 15 seconds Filtration direction: Reverse filtration is only possible at low pressure Sterilization: Can be autoclaved at 121°C for 20 minutes (maximum temperature 132°C). Can be autoclaved repeatedly, but users are responsible for avoiding cross-contamination. Integrity testing should be performed after autoclaving. Can be sterilized with ethylene oxide gas. No pyrogens: No reaction in total LAL test Effective filtration area: 500cm2 Pore ​​size (μm): 0.2 Housing type: Encapsulated Connection inlet: SB Connection outlet: SB SB = stepped hose barb: can be connected to 6-10mm (1/4”-3/8”) tubes