Union Tool Carbide End Mill CXS4025-135 1 piece

Catalog number: CXS4025-135 Features: ● Unequal division and unequal lead specifications suppress chatter vibration. ● High toughness type carbide material that is difficult to chip is used, and fine tuning including special groove shape enables ultra-high efficiency cutting that has never been seen before. ● Not only high efficiency cutting but also good finish surface can be obtained in finishing cutting. ● Low friction coating is applied, achieving outstanding chip removal and wear resistance. Applications: ● Compatible workpiece materials: carbon steel, alloy steel, pre-hardened steel, hardened steel (up to 55HRC), cast iron, copper (wet), titanium alloy (wet), super heat-resistant alloy (wet) Specifications: ● UT coating ● Twist angle 37° to 40° ● Unequal division Unequal lead 4-blade high efficiency long neck square end mill CXS Material / Finish: ● Carbide fine particle alloy (Super MG) Note: ● Shank taper angle is a guideline. ● If interference with the workpiece is required, be sure to measure it and check it. ● Be careful not to let the shank come into contact with the workpiece. ● To prevent the tip of the blade from vibrating, do not chuck the shank if it has coating on it.