Union Tool 2-blade short shank ball R0.2 x blade length 0.4 x shank taper angle 16° x total length 35 HSB2004-0040S 1 piece

Catalog number: HSB2004-0040S Features: ●Short shank ball compatible with high-precision shrink-fit holders. ●Achieves higher machining efficiency, longer life, and higher-quality machined surfaces than ever before when machining high-hardness mold materials of 40HRC or higher. ●Uses HARDMAX coating that enhances film hardness while maintaining high levels of heat resistance, toughness, and lubricity. ●Stable machining is possible with water-soluble or oil-based cutting oil, oil mist, or air blow. ●The rake angle on the outer periphery of the ball is set to a weak negative angle to ensure sharpness, provide a good machined surface, and prevent tipping. Uses: ● Compatible workpiece materials: Pre-hardened steel, hardened steel (up to 55HRC) (up to 60HRC) (up to 70HRC), carbon steel, alloy steel, cast iron, copper, titanium alloy, super heat-resistant alloy Specifications: ● Ball radius (mm): R0.2 ● Blade length (mm): 0.4 ● Overall length (mm): 35 ● Shank diameter (mm): 4 ● Number of blades (pieces): 2 ● Surface treatment: HARDMAX ● Twist angle (°): 30 ● Number of blades: 2 ● Shank taper angle (°): 16 ● 2-blade HARDMAX short shank ball end mill ● Twist angle 30° Material/Finish: ● Ultra-fine grain carbide alloy (Super MG) Caution: ● The shank taper angle is a guideline. ● If interference with the workpiece is required, be sure to measure it and check it. ● Be careful of contact between the shank and the workpiece.