Water level controller WLC-SA2 1 piece

The water level sensor is a suction cup type, so it can be installed at any depth inside the tank. (Cable length: approx. 300mm) The water level sensor can be replaced with a foot switch (sold separately), and forced water delivery is also possible using the foot switch. There is a hole (daruma hole) on the back for wall mounting, and it can be fixed with two M4 screws. Because it uses a tube pump, the tube can be replaced. (*Tubes have a limited lifespan.) Equipped with a water level sensor, automatic liquid transfer is possible! Maximum flow rate (L/min): 1.2 Maximum lift height (m): 1.8 Maximum flow rate: 1.2L/min (flow rate adjustable) Liquids used: Water-based solutions below 60°C (drinking water, neutral detergent, etc.) *Organic solvents, viscous liquids, and slurries are not permitted. Water level detection: Float type Sensor material: Modified PPO (polyphenylene oxide), PP, SUS304, * Operating temperature: -10 to +80°C Power supply: AC100~240V 50/60Hz 2.7A Power cord length: Approx. 1.5m Accessories: AC adapter Compatible tube: Silicon tube with inner diameter Φ10mm and outer diameter Φ13mm *Water supply tank (container) is not included. 【Note】 This product is not supported for disassembly, modification, or use with parts other than the included or genuine optional parts. In addition, we cannot disclose information such as component specifications, electrical circuit diagrams, software, etc.