Junkosha One-touch fitting W series nipple 6mm PT1/8 WN-06-01 1 pc

Catalog number: WN-06-01 Features: ●All resin parts are UL94V-0 equivalent. ●All resin parts are UR (PT) The pull-out strength of the screw resin press-in part is 30% higher than conventional products. ●The new tube grip mechanism dramatically improves impact resistance. ●The tube grip rotates smoothly inside the fitting, preventing the tube from being cut due to rotation. ●All seal materials such as O-rings and V-seals are made of water-resistant NBR. ●No sealing tape is required. ●R (PT) threaded parts are sealed. ●The body can be positioned according to the tube removal direction. ●The joint between the R (PT) threaded part and the resin of elbows and tapes can rotate, allowing free positioning according to the tube removal direction after fitting installation. Applications: ●For air pressure and water pressure piping for automotive spot welding equipment. ●For piping that requires impact resistance. ●For flame-retardant piping. Specifications: ● Compatible tube outer diameter D (mm): 6 ● Hexagonal side (mm): 14 ● Connection size: PT1/8 ● Operating temperature range (℃): Air: 0 to 60℃, Water: 0 to 60℃ (Do not freeze.) ● Fluid used: Air, water ● Fluid used: Air, water ● Fluid temperature: 0 to 60℃ (air), 0 to 60℃ (water *Do not freeze) ● Maximum operating pressure: 0.97MPa (air), 0.29MPa (water) ● Vacuum pressure used: 1.4kPa or more (if the fluid used is air) ● Applicable tubes (if the fluid used is air): Nylon tubes (AS1, AS4), Spot welding equipment tubes (SP4, SPF), Polyurethane tubes (UH, UF, UFL, UE, UC) ● Applicable tubes (if the fluid used is water): Nylon tubes (AS1), Spot welding equipment tubes (SP4, SPF) Material/Finish: ● Body (metal parts): Brass Note: If the maximum working pressure of the tube is lower than the above pressure, please use it at or below the maximum working pressure of the tube. If using a tube other than the applicable tube, please use a tube with an outer diameter precision of within ±0.1 mm for nylon and within ±0.15 mm for urethane, and with a roundness of within 0.2 mm (maximum outer diameter - minimum outer diameter).