A&D voltage detector AD-5571 AD-5571 1 unit

Catalog number: AD-5571 Features: ●A non-contact voltage tester that notifies the voltage detection status with a red LED and a buzzer. ●The sensitivity can be easily switched with a button. ●Low voltage response mode (24 to 1000V): The status display panel lights up green. ●High voltage induction mode (90 to 1000V): The status display panel lights up red. ●Equipped with a white LED light at the tip, which is convenient when working in dark places. ●Can be used even when the main unit is turned off. ●Measure by placing the detection part parallel to the object to be measured. ●Equipped with an auto power off function. ●Equipped with a low battery display function. When the battery voltage drops, the status display panel flashes yellow-green three times, a buzzer sounds, and the power is turned off. ●Commercially available straps can be attached. Applications: ●In low voltage response mode, it can be used to detect low voltage AC motors (90V), audio systems, arc welding, insulated cables, and other weak electromagnetic AC signals. ●Use the high voltage induction mode to inspect power supply lines and three-phase AC power sources such as distribution boxes, distribution boards, electrical appliances, and electrical equipment. Specifications: ●AC voltage (V): 24-1000 ●Power supply (V): 2 AAA batteries ●Width (mm): 150 ●Depth (mm): 23 ●Height (mm): 18 ●AC voltage (in high sensitivity mode) (V): 90-1000 ●Frequency range: 50Hz/60Hz ●AC voltage range: 90-1000VAC (when red LED is lit: high voltage induction mode), 24-1000V AC (when green LED is lit: low voltage response mode) ●Alarm method: Buzzer/red LED flashing ●LED light: White LED ●Auto power off: Approximately 5 minutes ●Low battery indication: Yes ●Battery life: Approximately 200 hours ●Maximum operating temperature and humidity range: 0-40°C 80% RH or less (no condensation), 2000m or less above sea level ●Overvoltage category: CAT 4 Set contents/accessories: ●Instruction manual, batteries (for monitor) Caution: ●*Make sure to place the detection part correctly so that it is parallel to the object to be measured.