HALDER Floating Clamp M12 23320.0012 1 piece

Catalogue number: 23320.0012 Features: ●Suppresses vibration of the workpiece during processing. ●Can clamp ribs and tongue-shaped parts of the workpiece, and can clamp the workpiece without deforming it during primary processing of castings, etc. ●For 23320.0012 and 23320.0016, the workpiece is fixed when the clamp nut is tightened, and the cylinder body is fixed vertically at the same time. ●For 23320 and 0014, the workpiece and cylinder body are fixed with separate clamp nuts. Applications: ●Used to clamp and hold the parts of the workpiece that are prone to chatter vibration after fixing the workpiece to the jig at three points. Specifications: Height (mm): Max 177 Rotation direction and angle: Left and right 110° Stroke (mm): 12 Clamping force (kN): 8 Mounting screw (mm): M12 8kN (30Nm) Fix the floating clamp to the base plate of the fixture using the M12 at the bottom of the main body (wrench has a two-sided width of 46mm). Adjust the vertical and rotational positions of the stopper (red cover) and secure with three set screws (hexagonal wrench has a two-sided width of 2.5mm). Be sure to leave sufficient slack in the upward direction (because there is a dimensional tolerance of the workpiece). Handling clamp procedure: Press down on the entire jaw part of the floating clamp. Rotate the jaw part to bring it into position to clamp the workpiece (adjust the position of the stopper in advance). Release your hand and the lower jaw will come into contact with the workpiece with a small spring force. Tighten the hexagonal nut (two-sided width 18mm) (minimum torque 15Nm, maximum torque 30Nm). ●At this time, the workpiece is clamped and at the same time the entire nozzle is fixed in the vertical direction. ●To release the clamp, follow the procedure in reverse. ●Standard nozzle included Material/Finish: ●Housing: Aluminum, red oxide film treated body hardened steel ●Body: Hardened steel, nitriding treatment, manganese phosphate treatment, polished ●Nozzle: Hardened steel, nitriding treatment, manganese phosphate treatment Set contents/Accessories: ●Lower nozzle: 23320.0050 ●Upper nozzle: 23320.0052 Note: ●Note: To ensure functionality, the screw hole at the bottom must always be blocked with an M12 x10 bolt or similar.