SANWA True RMS compatible DC/AC compatible digital clamp meter DCM600DR 1 unit

Catalogue number: DCM600DR Features: ●Can measure up to AC/DCA 600.0A. ●Can measure true RMS values. ●Backlight included. ●Peak hold function (1ms) included. ●Can measure distorted waveforms using true RMS detection method. ●Relative function (relative value display), data hold function. ●Equipped with a disabling auto power save function that operates after approximately 30 minutes. Applications: ●For maintenance of facility equipment. ●For maintenance of power equipment such as automobiles. Specifications: ●DC current (A): 600 ●AC current (A): 600 ●DC voltage (V): 600 ●AC voltage (V): 600 ●Resistance (Ω): 999.9 ●Detection method: True RMS method ●Calibration documents: Supported ●Power supply (V): 2 AAA alkaline batteries (LR03) (included) ●Width (mm): 69 ●Depth (mm): 38 ●Height (mm): 208 ●Power supply: 2 AAA alkaline batteries (LR03) (included) ●Continuity check: Buzzer sounds at approximately 40 Ω or less Open voltage 2.9 V ●Maximum measurement conductor diameter (mm): 50 ●Clamp diameter (mm): 30 ●Maximum display: 6000 counts ●Width x Depth x Height: 69 x 38 x 208 mm ●Battery life: 40 hours Set contents / accessories: ●Test lead ●Carrying case ●Instruction manual ●Portable case C-DCM660 ●Test lead TL-23a Caution: ●This is a low-voltage clamp meter. Do not use on circuits with a voltage to ground exceeding 600V. ●Do not switch to other functions during measurement. ●When connecting to or disconnecting from a live conductor, always wear insulating protective gear such as electrical rubber gloves. ●Do not input signals that exceed the maximum rated input value. ●During measurement, do not hold the test pin side of the test probe beyond the barrier or the part beyond the barrier of the clamp sensor.